An Experimental Investigation on Partial Replacement of ...
Mineral admixture : Steel Slag Fine aggregate : Natural Sand & M - Sand Coarse aggregate Water Chemical admixture : Super plasticizer Cement-The cement used for casting the specimens is of 53 grade ordinary Portland cement as per as per IS 12269-1987. The required quantity is procured, stored in airtight bags and used for experimental programme.
Partial Replacement of Steel Slag Aggregates in Concrete ...
12%In this study, an attempt has been made to investigate the effect of partial replacement of conventional river sand with steel slag aggregate. The replacement of river sand by slag aggregate provides dual advantage of reducing disposal problems in steel industries and conserving the natural resources.
Steel Slag as a Partial Replacement of Fine Aggregate In ...
3.3 Course Aggregate: After sieve analysis, the retained aggregate of size 4.75mm left are the coarse aggregates used in this experiment. 3.4 Steel Slag: Fine loose steel granular materials collected from steel furnaces stored as waste in a bulk for further replacement levels in this experiment. 3.5. Water: Clean tap water is used in this ...
Experimental Investigation Of Coarse Aggregate With Steel ...
concrete made by steel slag aggregates. The following size of slag available from JSW Steel Ltd,0-4mm,4-12mm,12-20mm,20-40mm and above 40mmCrushed granite aggregate with specific gravity of 2.77 and passing through 4.75 mm sieve and will be used for casting all specimens. Several investigations concluded that
Effect of Steel Slag as a Partial Replacement Fine ...
The results point out that for conventional concrete, the partial replacement of fine aggregates by steel slag improves the compressive, ultrasonic pulse velocity and tensile strength. In a nutshell, the result obtained for concrete mixes with 15% steel slag fine aggregate and at 28 days established that these mixes are good for production of ...
Experimental Investigation on Partially Replacement of ...
Appropriate utilization of the combination of these two materials as a partial replacement for cement and coarse aggregate will bring ecological and economic benefits to the country. II. MATERIAL PROPERTIES Material Used 1) Cement 2) Coarse Aggregate 3) Fine Aggregate 4) Replacement steel slag (partial Replacement of coarse aggregate 40%, 50% ...
Experimental Investigation of Fibre Reinforced Concrete ...
Steel slag was found to be the best replacement for natural aggregates of concrete. Steel slag which is produced as a waste material in the steel industry and has a negative impact on environment when disposed. In the course of future project work by the replacement of steel slag for the coarse aggregate in concrete of 25%, 50%, 75% & with ...
Partial Replacement Of Fine Aggregate Using Steel Slag
steel slag as partial replacement of fine aggregate. For this purpose different test on harden concrete were conducted at the age of 28 days like compressive strength on 150 x 150 x 150 mm size cube, splitting tensile strength on 150 mm X 300 mm cylinder, flexural strength on beam of …
Utilisation of silica fume & steel slag in concrete as a ...
To increase the strength of concrete by partial replacement of coarse aggregate with steel slag which is a waste material produced from steel industries. The main objective of this project is to get high strength by using normal mix proportions with partial replacement of silica fume in cement and steel slag in coarse aggregate. International ...
Performance of concrete made with steel slag and waste ...
Lightweight aggregate with a nominal size of 14 mm was used as coarse aggregate in mix LWC-2, and coarse steel slag (4.9–20 mm) was used to replace all coarse aggregate in mix CSSC-2. For mix SSGC-2, waste glass (4.9–10 mm) was used to replace 17.5% by volume of coarse aggregate, and the remaining coarse aggregate was replaced by coarse ...
International Journal of ChemTech Research
investigation deals with usage of steel slag as a partial replacement coarse aggregate and M-Sand to fine aggregate respectively. Initially the optimum percentage steel slag to be replaced is found out by conducting 28 days compressive strength on cubes of size 150 mm
Experimental Investigation on Partial Replacement of ...
Experimental Investigation on Partial Replacement of Natural Fine Aggregate by Steel Slag and Natural Coarse Aggregate by Waste Limestone Aggregate in Cement Concrete Md Zeeshan1 Prof. Rohan S Gurav2 Prof. Brij Bhushan S3 Prof. Maneeth P D4 1M. Tech Student 2,3,4Assistant Professor 1,2,3,4Department of Construction Technology
Strength Analysis of Concrete by Using Iron Slag as a ...
Strength Analysis of Concrete by Using Iron Slag as a Partial Replacement of Normal Aggregate (Coarse) in Concrete Khalid Raza1, Apoorv Singh2, R. D. Patel3 1,2P.G. Scholar, Department of Civil Engineering, M.M.M.U.T. Gorakhpur, India Abstract: Iron slag is an industrial waste by-product of steel industry. The demand for aggregate in ...
A STUDY ON CONCRETE PROPERTIES USING STEEL SLAG AS …
This paper aims to study experimentally, the effect of partial replacement of coarse aggregate by steel slag (SS), on the various strength and durability properties of concrete, by using the mix design of M40 grade. In this study, steel slag was used
Experimental investigation on partial replacement of steel ...
The usage of Steel slag also improved the crack resistance and reduces the early crack development. 3. The E-plastic waste is used to replace the coarse aggregate with certain percentage shows slight improvement in the steel slag replacement. This type of replacement will reduce the dumping of waste that are polluting the environment. 4.
Partial replacement of fine aggregate by steel slag and ...
Nandini Suri et al., (2016) "Experimental Investigations On Partial Replacement Of Steel Slag As Coarse Aggregates And Eco Sand As Fine Aggregate", Int. J. Civil Eng. Technol. (IJCIET), Volume 7, Issue 5, September-October 2016, pp 322-328.
Comparative Study On Partial Replacement For Fine ...
chemical properties of steel slag and weld slag in concrete. Steel slag and weld slag could be used as a partial replacement for fine aggregate concrete mixture will be improved in the properties by addition of steel slag and weld slag in concrete is observed. The concrete has the ability to reuse the waste product, by replacing the
What material can I use as a replacement of coarse ...
Answer (1 of 6): It is advisable to not replace gravels with other consituents as possible as you can. Ofcourse coarse aggregates can be replaced with broken concrete debris however we are compromising the quality of resultant concrete upto some level that doesnt make any harm to building as a …
Utilization of Giad Steel Slag as Partial Replacement for ...
53 Utilization of Giad Steel Slag as Partial Replacement for Coarse Aggregates in Concrete Osama Daoud1,* and Muntasir Ibrahim2 1 Building and Road Research Institute, Khartoum, Sudan 2 Civil Engineering Department, University of Khartoum, Khartoum, Sudan * Corresponding author: Osama Daoud (e-mail: [email protected]). Article history: Received 14 March 2020, Received in …
Partial Replacement of Rubberized Material as Coarse ...
aggregates as coarse aggregates in concrete. A modified concrete is prepared by replacing coarse aggregates in concrete with rubber aggregates by varying the replacement proportion of 20% and 25%. cubes and cylinder for each percentage of replacement …
IJETT - Technical Assessment on Performance of Partial ...
Prof. Warudkar Abhijit A., Mr. Nigade Y.M "Technical Assessment on Performance of Partial Replacement of Coarse Aggregate by Steel Slag in Concrete", International Journal of Engineering Trends and Technology (IJETT), V30(1),37-41 December 2015. ISSN:2231-5381. published by seventh sense research group. Abstract Road Construction is an activity in which natural …
Experimental Investigation on Partial Replacement of ...
concrete using industrial steel slag as partial-replacement of natural-sand and steel fiber as an additive to the cement concrete and establish the ... specific gravity of coarse aggregate is 2.83 and water absorption is 0.80%. The size of the coarse aggregate is 20mm down is …
Experimental Study on Partial Replacement of Fine ...
partial replacement of fine aggregate by steel slag on the various strength properties of concrete by using the mix design of M20 grade. Test specimen with 0, 10, 20, 30, 40&50% of partial replacement of fine aggregate by steel slag were cast and tested for compressive strength after curing period of 7 …
Properties of Concrete Manufactured Using Steel Slag ...
Abstract This paper aims to study experimentally, the effect of partial replacement of coarse and fine aggregates by steel slag (SS), on the various strength and durability properties of concrete, by using the mix design of M20 grade. The optimum percentage of replacement of fine and coarse aggregate by steel slag is found. Workability of concrete gradually decreases, as the percentage of ...
Study on Strength Properties of Concrete by Partially ...
made with steel slag as replacement for aggregates. For this present study M20 concrete will be designed. Partial replacement of sand with steel slag will be made for varying percentages such as 10%, 20%, 30%, 40% and 50% of weight of sand. Studies on compressive strength, tensile strength, flexural strength and stress-
Analysis of flexible pavement with steel slag as coarse ...
Steel slag was selected due to its characteristics which are almost similar to conventional aggregates and the fact that it is easily obtainable as a by-product of the steel industry. Steel slag has been considered for replacement of coarse aggregate in binder layer …
Experimental Study On Partial Replacement Of Fine ...
partial replacement of coarse and fine aggregates with steel slag and steel mill scale will increases the strength of about 30% to 50%. The main aim of this research was to study the behavior of concrete and changes in the properties of concrete with steel slag and steel mill scale by replacing the use of natural aggregates.
A Experimental Study on Partial Replacement of Cement with ...
A Experimental Study on Partial Replacement of Cement with Metakaolin and Coarse Aggregate with Blast Furnace Slag - written by Shaik Fazlur Rahman, Smt. K Chandrakala published on 2019/12/23 download full article with reference data and citations
Technical Assessment on Performance of Partial Replacement ...
Portland Cement 53 grade, fine aggregate, coarse aggregate and steel slag for checking their suitabilities for making concrete. Mix proportions of concrete are modified for using EAF steel slag with partial replacement of coarse aggregate replaced with 0%, 25%, 50%, 75% and …
Study on the partial replacement of fine aggregate using ...
the industrial area. Through the present work, the use of induction furnace slag as a partial replacement for the fine aggregate in cement mortar and cement concrete is studied. R. Alizadeh et al. [3] studied on the utilization of electric arc furnace slag as aggregates in concrete. The physical, chemical and mechanical properties of steel slag ...